IKEA LHGA4K 501-560-08 User Manual download pdf (Page 12)

The connection of the cooktop to the gas

pipe network or gas cylinder must be made

by means of a rigid copper or steel pipe

with fittings complying with local regula-

tions, or by means of a continuous surface

stainless steel hose complying with local

regulations.

If you see any abnormalities do not re-

pair the pipe, contact local After Sales

Service (refer to the Service chapter).

The connection must be installed correctly,

fixed into hob connection pipe. Otherwise it

will cause leakage of gas

Warning! Once the installation is

complete, check the perfect seal of

every pipe fixing. Use soapy water, never

flame.

Electrical connection

Before connecting, check that the nominal

voltage of the appliance stated on the rat-

ing plate, corresponds to the available sup-

ply voltage. Also, check the power rating of

the appliance and ensure that the wire is

suitably sized to suit the appliance power

rating (refer to the Technical data chapter).

The rating plate is located on the lower cas-

ing of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a prop-

er plug, able to support the load marked on

the identification plate.

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you in-

stall a double pole switch between the ap-

pliance and the electricity supply, with a

minimum gap of 3 mm. between the switch

contacts and of a type suitable for the re-

quired load in compliance with the current

rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

temperature 90 °C higher than the room

temperature. The brown (or black) phase

cable (fitted in the terminal block contact

marked with "L") must always be connected

to the network phase.

1

2

Replacement of the connection cable

Warning! The replacement of the

connection cable requires the specific

equipment of a technician.

In this case, only cable type H05V2V2-F

T90 must be used. The cable section must

be suitable to the voltage and the working

temperature. The yellow/green earth wire

2

must be approximately 2 cm longer than

the brown (or black) phase wire

1

(previ-

ous figure).

Gas setting conversion

This model is designed for use with

natural gas but can be converted for

use with butane or propane gas providing

the correct injectors. The injectors not sup-

plied with the appliance have to be or-

dered from After Sales Service (refer to the

Service chapter).

For data concerning injector replacement,

refer to the chapter Technical data

Warning! Conversion or replacement

can only be performed by a registered

installer.

To replace injectors:

1. Remove pan support.

2. Remove burner cap and crown.

ENGLISH 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 83 84

Comments to this Manuals

No comments