IKEA FHGA1K User Manual download pdf (Page 9)

Ensure that the local distribution condi-

tions (nature of the gas and gas pres-

sure) and the adjustment of the appliance

are compatible before proceeding with the in-

stallation.

The parameters of adjustment setting for

this appliance are stated on the rating

plate (refer to the Technical data chapter).

Warning! The appliance must be

earthed!

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of volt-

age.

• Loose and inappropriate plug and socket

connections can make the terminal over-

heat.

• Have the clamping connections correctly in-

stalled.

• Use strain relief clamp on cable.

Important! You must observe the minimum

distances to other appliances and furniture

cabinets or other units according to Assembly

Instruction.

If there is no oven beneath the hob insert a di-

viding panel at a minimum distance of 20 mm

from the bottom of the hob.

Protect the cut surfaces of the worktop

against moisture using a suitable sealant in-

cluded in the product in fitting bag. The seal-

ant seals the appliance to the work top with

no gap. Do not use silicon sealant between

the appliance and the worktop. Avoid instal-

ling the appliance next to doors and under

windows as hot cookware may be knocked

off the pan support when doors and windows

are opened.

Gas Connection

Warning! This appliance is not

connected to a combustion products

evacuation device.

Installation must comply with current local reg-

ulation.

The connection of the cooktop to the gas

pipe network or gas cylinder must be made

by means of a rigid copper or steel pipe with

fittings complying with local regulations, or

by means of a continuous surface stainless

steel hose complying with local regulations.

If you see any abnormalities do not re-

pair the pipe, contact local After Sales

Service (refer to the Service chapter).

The connection must be installed correctly,

fixed into hob connection pipe. Otherwise it

will cause leakage of gas

Warning! Once the installation is

complete, check the perfect seal of every

pipe fixing. Use soapy water, never flame.

Electrical connection

Before connecting, check that the nominal volt-

age of the appliance stated on the rating

plate, corresponds to the available supply

voltage. Also, check the power rating of the

appliance and ensure that the wire is suitably

sized to suit the appliance power rating (re-

fer to the Technical data chapter).

The rating plate is located on the lower cas-

ing of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a proper

plug, able to support the load marked on the

identification plate (refer to the Technical da-

ta chapter).

The plug has to be fitted in a proper socket. If

connecting the appliance directly to the elec-

tric system, it is necessary that you install a

double pole switch between the appliance

and the electricity supply, with a minimum

gap of 3 mm between the switch contacts.

The double pole has to be of a type suitable

for the required load in compliance with the

current rules.

The connection cable has to be placed in or-

der that, in each part, it cannot reach a 90 °C

temperature. The blue neutral cable must be

connected to the terminal block marked with

"N". The brown (or black) phase cable (fitted

in the terminal block contact marked with "L")

must always be connected to the live phase.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Comments to this Manuals

No comments