IKEA RIWM60 User Manual download pdf (Page 11)

Start the programme by pressing button 5

To start the selected programme, press the

button 5, the corresponding green indicator

light stops blinking. The indicator light corre-

sponding to the running phase illuminates. The

appliance starts operating and the door is

locked.

To interrupt a programme which is running,

press the button 5: the corresponding green

indicator light starts blinking.

To restart the programme from the point at

which it was interrupted, press the button 5

again. If you have chosen a delayed start, the

appliance will begin the countdown.

If an incorrect option is selected, the red indi-

cator light of the button 5 blinks 3 times.

Altering an option or a running programme

It is possible to change some options before

the programme carries them out.

Before you make any change, you must PAUSE

the appliance by pressing the button 5.

Changing a running programme is possible

only by resetting it. Turn the programme se-

lector dial to O and then to the new pro-

gramme position. Start the new programme by

pressing the button 5 again. The washing wa-

ter in the tub will be not emptied out.

Interrupting a programme

Press the button 5 to interrupt a programme

which is running, the corresponding green in-

dicator light starts blinking.

Press the button again to restart the pro-

gramme.

Cancelling a programme

Turn the selector dial to O to cancel a pro-

gramme which is running.

You can select now a new programme.

Opening the door

After the programme has started the door is

locked. If, for any reason, you need to open it,

set firstly the appliance to PAUSE by pressing

the button 5. After a few minutes it will be pos-

sible to open the door.

If the door remains locked, this means that the

appliance is already heating or that the water

level is too high. In any case, do not try to force

the door!

If you cannot open the door but you need to

open it you have to switch the appliance off by

turning the selector dial to O . After a few mi-

nutes the door can be opened (pay attention

to the water level and temperature!).

After closing the door, it is necessary to select

the programme and options again and to

press button 5.

At the end of the programme

The appliance stops automatically. The indi-

cator light of button 5 and the indicator light

corresponding to the just finished washing

phase goes off. The light 7.3 illuminates. After

a few minutes the door can be opened.

If a programme or an option that ends with

water left in the tub has been selected, the light

7.3 illuminates but the door remains locked to

indicate that the water must be emptied out

before opening the door.

Follow the below instructions to empty out the

water:

1. Turn the programme selector dial to O .

2. Select the draining or spinning pro-

gramme.

3. Reduce the spin speed if needed, by press-

ing the button 2.

4. Press button 5.

At the end of the programme, the door can be

now opened. Turn the programme selector di-

al to O to switch the appliance off.

Remove the laundry from the drum and care-

fully check that the drum is empty. If you do not

intend to carry out another wash, close the

water tap. Leave the door open to prevent any

mildew and unpleasant smells.

Stand by : once the programme has fin-

ished the energy saving system is ena-

bled with the pilot lights switched on. By press-

ing any button the appliance will come out of

the energy saving status.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 107 108

Comments to this Manuals

No comments