IKEA RENLIG User Manual download pdf (Page 22)

Cleaning the inlet filter and the filter valve

If the appliance takes long to fill with water

or doesn't fill, the starting button indicator

flashes in red. Check if the water inlet filter

and the valve filter are blocked (see

chapter "Troubleshooting" for more details).

Proceed as follows:

• Turn off the water

tap.

• Unscrew the hose

from the tap.

• Clean the filter in

the hose with a stiff

brush.

• Screw firmly the

inlet hose back

onto the tap.

• Unscrew the hose from the appliance.

Keep a rag nearby because some water

may flow.

• Clean the filter in the valve with a stiff

brush or with the piece of cloth.

35°

45°

• Screw the hose

back to the

appliance turning

it to the left or the

right to suit the

installation. Tight

the locknut

correctly to

prevent water

leaks.

• Turn on the water tap.

The dangers of freezing

If the appliance is installed in a place where

the temperature could drop below 0°C,

proceed as follows to remove any water

remaining inside the appliance:

• unplug the appliance;

• turn off the water tap;

• place the end of the emergency

emptying hose and that of the inlet hose

in a bowl placed on the floor and let

water drain out;

• screw the water inlet hose back on and

reposition the emergency emptying hose

after having put the cap on again;

• When you intend to start the appliance

up again, make sure that the room

temperature is above 0°C.

Every time you drain the water

through the emergency emptying

hose you must pour 2 litres of

water into the main wash

compartment of the detergent

drawer and then run the drain

programme. This will activate the

ECO VALVE device avoiding that

part of the detergent remains

unused at next washing.

Emergency emptying out

If the water is not discharged, proceed as

follows to empty out the appliance:

• unplug the appliance;

• turn off the water tap;

• if necessary, wait until the water has

cooled down;

• open the filter door;

• place a bowl on the floor and place the

end of the emergency emptying hose

into the bowl. Remove its cap. The water

should drain by gravity into the bowl.

When the bowl is full, put the cap back

on the hose. Empty the bowl. Repeat the

procedure until water stops flowing out;

• clean the filter if necessary as previously

described;

ENGLISH

22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments