IKEA EUR Instruction for Use download pdf (Page 5)

ENGLISH 5

• Air vents must always discharge to the

outside.

• The manufacturer rejects all

responsibilities for any damage caused

by improper use or wrong settings.

• Appropriate maintenance and cleaning

ensure the good working order and

the best performance of the appliance.

Regularly clean all stubborn surface dirt

to avoid grease build up. Remove and

clean or change the ﬁ lter regularly.

• Never ﬂ ame cook food (ﬂ ambé) under

the appliance. Using free ﬂ ames might

cause ﬁ re.

• Failure to observe the instructions for

cleaning the hood and replacing the

ﬁ lters may result in a ﬁ re.

• Exhaust air must not be vented through

a ﬂ ue used for removal of fumes

produced by gas combustion appliances

or other combustible materials, but must

have a separate outlet. All national

regulations governing extraction of

fumes must be observed.

• There shall be adequate ventilation if

the hood is being used at the same time

as other appliances using gas or other

combustible materials. The negative

pressure of the room must not exceed 4

Pa (4x 10-5 bars). For this reason ensure

that the room is well ventilated.

• Do not leave frying pans unattended

when frying, as the frying oil may catch

ﬁ re.

• Before touching the light bulbs, ensure

that they are cold.

• Do not use or leave the hood without

the light bulb correctly ﬁ tted, as this may

cause electric shock.

• The hood is not a work surface, therefore

do not place any objects on top of it or

overload it.

• During all installation and maintenance

operations wear appropriate working

gloves.

• This appliance is not suitable for outdoor

use.

WARNING: when the hob is in use,

accessible parts of the hood may

become hot.

Installation and connection

After unpacking the appliance, check for

any transport damage. In the event of

problems, contact the After-sales Service.

To prevent any damage, only remove

the appliance from its polystyrene foam

packaging at the time of installation.

Preparing for installation

WARNING: this is a heavy product; the

hood should only be lifted and

installed by two or more people.

The minimum distance between the hob and

the bottom part of the hood must not be less

than 65 cm for gas cookers and 50cm for

electric cookers.

Before installation also check the minimum

distances stated in the manual of the cooker.

If the installation instructions for the cooker

specify a greater distance between cooker

and hood, this distance must be observed.

Electrical connection

Make sure the power voltage speciﬁ ed on

the appliance rating plate is the same as

the mains voltage.

This information can be found on the inside

of the hood, under the grease ﬁ lter.

Power cable replacement (type H05

VV-F) must be carried out by a qualiﬁ ed

electrician. Contact an authorized service

centre.

If the hood is ﬁ tted with an electric plug,

connect the plug to a socket complying with

current regulations, located in an accessible

place.

If no plug is ﬁ tted (direct wiring to the

mains), or if the socket is not located in an

accessible place, a qualiﬁ ed electrician

should install a standardised double pole

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comments to this Manuals

No comments