IKEA HB G20 S Instruction for Use download pdf (Page 12)

ENGLISH 12

made by means of a rigid copper or

steel pipe with ttings complying with

local regulations, or by means of a

continuous-surface stainless steel hose

complying with local regulations. The

maximum length of the hose is 2 linear

metres.

- Connect elbow (A) or (B) supplied with

to the hob inlet main pipe and interpose

the washer (C) supplied, in compliance

with EN 549.

- Use elbow (A) for France and elbow (B)

for all other destinations.

- IMPORTANT: if a stainless steel hose

is used, it must be installed so as not to

touch any mobile part of the furniture.

It must pass through an area where

there are no obstructions and where it is

possible to inspect it on all its length.

- After connection to the gas supply, check

for leaks with soapy water. Light up the

burners and turn the knobs from max

position

to minimum position to

check ame stability

Electrical connection

WARNING

- This operation must be performed by a

qualied technician.

- The electrical connections must comply

with local regulations.

- The earthing of this appliance is

compulsory by law.

L

N

Earth

(yellow/green)

- Do not use an extension cord.

- IMPORTANT: the data relevant to the

voltage and power absorption are

indicated on the rating plate.

Assembly

After having cleaned the perimeter surface,

apply the supplied gasket to the hob.

Position the hob in the worktop opening

made respecting the dimensions indicated

in the Instruction.

NOTE: the power supply cable must be long

enough to permit its upward extraction.

To secure the hob, use the brackets provided

with it.

Fit the brackets into the relevant bores

shown by the arrow and fasten them by

means of their screws in accordance with

the thickness of the worktop.

Make sure that the outlet is near the product

A

B

C

C

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Comments to this Manuals

No comments