IKEA FHGA5K 902-007-02 User Manual download pdf (Page 11)

The appliance is supplied with a connection

cable. This has to be provided with a prop-

er plug, able to support the load marked on

the identification plate (refer to the Techni-

cal data chapter).

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you in-

stall a double pole switch between the ap-

pliance and the electricity supply, with a

minimum gap of 3 mm between the switch

contacts. The double pole has to be of a

type suitable for the required load in com-

pliance with the current rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

90 °C temperature. The blue neutral cable

must be connected to the terminal block

marked with "N". The brown (or black)

phase cable (fitted in the terminal block

contact marked with "L") must always be

connected to the live phase.

Replacement of the connection cable.

Warning! The replacement of electric

cable must be carried out exclusively

by the After Sales Service or by personnel

with similar competencies, in accordance

with the current regulations.

If the connection cable must be replaced,

only a type H05V2V2-F T90 cable must be

used. The cable section must be suitable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

To open the terminal block and reach the

terminals, proceed as follows:

1. insert the point of a screwdriver into

one of the two visible protruding part of

the terminal block

2. exert a light pressure and lift

Gas setting conversion

This model is designed for use with

natural gas but can be converted for

use with butane or propane gas providing

the correct injectors. The injectors not sup-

plied with the appliance have to be or-

dered from After Sales Service (refer to the

Service chapter).

For data concerning injector replacement,

see chapter "Technical data"

Warning! Conversion or replacement

can only be performed by a registered

installer.

To replace injectors:

1. Remove pan support.

2. Remove burner cap and crown.

3. With a socket spanner 7 unscrew and

remove the injectors, replace them with

the ones required for the type of gas in

use.

4. Reassemble the parts, following the

same procedure backwards.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

Comments to this Manuals

No comments