IKEA RENLIGFWM User Manual Page 27

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 26
Problem Possible cause Solution
The appliance
switches off dur-
ing the washing
phase:
The mains supply has been cut off. Wait for the electricity restore.
The appliance will start again
from the same interrupted wash-
ing phase.
The appliance
spinning phase
starts late or does
not start:
The electronic unbalance detec-
tion device has cut in because the
laundry is not evenly distributed in
the drum. The laundry is redistrib-
uted by reverse rotation of the
drum. This may happen several
times before the unbalance disap-
pears and normal spinning can re-
sume. If, after 10 minutes, the
laundry is still not evenly distrib-
uted in the drum, the appliance
will not spin.
Redistribute the load manually or
load more laundry and select the
spin programme.
There is water on
the floor:
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Reduce the detergent quantity or
use another one.
Check whether there are any
leaks from one of the inlet hose fit-
tings. It is not always easy to see
this as the water runs down the
hose; check if it is damp.
Check the water inlet hose con-
nection.
The drain or inlet hose is dam-
aged.
Replace it with a new one (check
with the Authorised Service Cen-
tre the right spare part number).
The door does not
open:
The programme is still running. Wait the end of washing cycle.
The door lock has not been re-
leased.
Wait a few minutes before open-
ing the door.
There is water in the drum. Select drain or spin programme
to empty out the water.
ENGLISH 27
Page view 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 67 68

Comments to this Manuals

No comments