IKEA RENLIGFWM User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
Proceed as follows:
1
Turn off the water
tap.
Unscrew the hose
from the tap.
Clean the filter in
the hose with a
stiff brush.
Screw firmly the
inlet hose back
onto the tap.
2
Unscrew the hose from the appliance.
Keep a rag nearby because some wa-
ter may flow.
Clean the filter in the valve with a stiff
brush or with the piece of cloth.
3
35°
45°
Screw the hose
back to the appli-
ance turning it to
the left or the
right to suit the
installation. Tight
the locknut cor-
rectly to prevent
water leaks.
Turn on the water
tap.
The dangers of freezing
If the appliance is installed in a place where
the temperature could drop below 0°C,
proceed as follows to remove any water re-
maining inside the appliance:
1. unplug the appliance;
2. turn off the water tap;
3. unscrew the water inlet hose from the
tap;
4. unfasten the drain hose from the rear
support and unhook it from sink or spi-
got;
1
2
5. place a bowl on the floor;
6. let the drain hose run along the floor,
place the external extremities of the
drain and inlet hoses in the bowl
placed on the floor and let water drain
out completely;
7. screw the water inlet hose back on and
reposition the drain hose again;
When you intend to start the appliance up
again, make sure that the room tempera-
ture is above 0°C.
What to do if…
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
- The appliance does not fill with
water.
- The appliance does not drain the
water.
ENGLISH 21
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Comments to this Manuals

No comments