IKEA RENLIGFWM User Manual download pdf (Page 6)

• Never use the appliance if the power

supply cable, the control panel, the work-

ing surface or the base is damaged so

that the inside of the appliance is accessi-

ble.

Water inlet

• This appliance must be connected to a

cold water supply.

• Do not use connection hoses from an old

appliance to connect it to the water sup-

ply.

• The water pressure must be in the limits

(refer to the chapter «Technical data» ta-

ble). Make sure that the local water au-

thority gives you the average mains pres-

sure in your area.

• Make sure that there are no kinks in the

water inlet hose and that the water inlet

hose is not squashed or entangled.

• Before connecting up the appliance to

new pipework or to pipework that has

not been used for some time, run off a

reasonable amount of water to flush out

any debris that may have collected in the

pipes.

• Turn the inlet hose on the back of the ap-

pliance to the left or the right to suit the

installation.

• The inlet hose must not be lengthened. If

it is too short and you do not wish to

move the tap, you will have to purchase a

new, longer hose specially designed for

this type of use.

• Before opening the water tap, be sure to

tighten the ring nut well to prevent any

leaks.

Water drainage

• Make sure the end of the drain hose can-

not come unhooked when the appliance

is emptying. This could be done by tying

it to the tap with a piece of string or at-

taching it to the wall.

• The drain hose must be placed at a

height of not less than 44 cm and not

more than 90 cm. Please refer to the As-

sembly Instruction booklet.

Care and cleaning

• Before maintenance, switch off the appli-

ance and disconnect the mains plug from

the mains socket.

• Clean the exterior cabinet of the appli-

ance with soap and water only, and then

dry thoroughly.

• The washing powder and additive dis-

penser drawer should be cleaned regu-

larly.

• Inspected the pump regularly and partic-

ularly if:

– the appliance does not empty and/or

spin

– the appliance makes an unusual noise

during draining due to objects such as

safety pins, coins etc. blocking the

pump.

• Never remove the pump cover during a

wash cycle. Always wait until the appli-

ance has drained out the water. If you

have selected an high temperature wash-

ing programme please wait until the wa-

ter has cooled down.

• Ensure that the pump cover is securely re-

tightened to prevent any leaks.

ENGLISH 6

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments