IKEA RENLIGFWM User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
The dangers of freezing
If the appliance is installed in a place where
the temperature could drop below 0°C, pro-
ceed as follows to remove any water remain-
ing inside the appliance:
1. unplug the appliance;
2. turn off the water tap;
3. unscrew the water inlet hose from the tap;
4. unfasten the drain hose from the rear
support and unhook it from sink or spigot;
1
2
5. place a bowl on the floor;
6. let the drain hose run along the floor,
place the external extremities of the drain
and inlet hoses in the bowl placed on the
floor and let water drain out completely;
7. screw the water inlet hose back on and
reposition the drain hose again;
When you intend to start the appliance up
again, make sure that the room temperature
is above 0°C.
What to do if…
The appliance does not start or stops during
operation. It is possible that the red indicator
light of button 5 blinks to indicate that the
appliance is not working.
Before contacting your local Service Centre,
please carry out the checks listed below.
Problem Possible cause Solution
The appliance
does not start:
The door has not been closed (The
red indicator light of button 5
blinks).
Close the door firmly.
The plug is not properly inserted in
the power socket.
Insert the plug into the power sock-
et.
There is no power at the socket. Please check your domestic electri-
cal installation.
The main fuse has blown. Replace the fuse.
The programme selector dial is not
correctly positioned and the button
5 has not been pressed.
Please turn the selector dial and
press the button 5 again.
The delay start has been selected. If the laundry are to be washed im-
mediately, cancel the delay start.
The appliance
does not fill:
The water tap is closed The red in-
dicator light of button 5 blinks).
Open the water tap.
ENGLISH 20
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments