IKEA RENLIG User Manual

RENLIGGB

Door lock indicator This indicator illuminates when the programme starts and indi-cates if the door can be opened:•indicator on: the door cannot be op

Spin reduction button By pressing this button you can change the spin speed of the se-lected programme.The relevant indicator illuminates.Rinse Hold o

Measure out detergent and fabricsoftenerPour the detergentinto the main washcompartment orin the appropriatecompartment if theselected programme/opt

To cancel the option:a. Press the button to set theappliance to pause. The indicator ofbutton flashes.b. Press the button until the displaysho

Draining the water:1. To drain the water.•Set a or a programme.•Press the button . The appliancedrains the water and spins.2. When the programme is

Degrees of water hardnessWater hardness is classified in so-called“degrees” of hardness. Information onhardness of the water in your area can beobtain

ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)HANDWASH40° - 30° - (Cold)2 kg900 rpmDelicate

ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)ON/OFFPosition to turn the appliance off or/an

Programme1)2) 3) 4) 1) This option is active only at 40° C and 60° C.2) When you set this option, we recommend that you decrease the qua

Off Mode (W) Left On Mode (W)The information given in the chart above are in compliance with the EU Commission regu-lation 1015/2010 implementing dire

Cleaning the drain filterProceed as follows:A BPlace a containerclose to the pump (A),to collect anyspillage.Pull out theemergency emptyinghose (B), p

• Unscrew the hose from the appliance.Keep a rag nearby because some watermay flow.•Clean the filter in the valve with a stiffbrush or with the piece

IntroductionThe start of the appliance does not occur or it stops during operation.With some problems, it is also possible that the red indicator of b

Problem Possible cause SolutionThe appliancedoes not fill thewater:The water tap is closed.(The red indicator of button flashes).Open the water tap.Th

Problem Possible cause SolutionThe applianceswitches off dur-ing the washingphase:The mains supply has been cut off. Wait for the electricity restore.

Problem Possible cause SolutionThe applianceproduces an un-usual noise:The transit bolts and packing havenot been removed.Check the correct installati

Dimensions Width (cm) 59,6Height (cm) 82Depth (cm) 54,4 maxWater supply pressure1)Minimum 0,5 bar (0,05 MPa)Maximum 8 bar (0,8 MPa)Cotton max. load (k

IKEA GUARANTEEHow long is the IKEA guarantee valid?This guarantee is valid for five (5) yearsfrom the original date of purchase of Yourappliance at IK

service contractual partner or wherenon-original parts have been used.•Repairs caused by installation which isfaulty or not according to specification

In order to provide You with aquicker service, we recommendthat You use the specific phonenumbers listed at the end of thismanual. Always refer to the

ENGLISH4

emit gninepOeeF llaCrebmun enohPyrtnuoCBelgië 070 246016 Binnenlandse gesprekskosten 8 tot 20 Weekdagen eniames nE .02 à 8 xuanoitan sleppa se

31

132901780-B-522015© Inter IKEA Systems B.V. 201521552AA-1609380-1

ContentsSafety information 4Safety instructions5Product description 7Control panel 8Before first use 11Daily Use 11Hints and tips 14Programmes 15Cons

• Cleaning and user maintenance shall not be made bychildren without supervision.General Safety• Do not change the specification of this appliance.• O

• Adjust the feet to have the necessaryspace between the appliance and thecarpet.•Do not install the appliance where theappliance door can not be full

Product descriptionAppliance overview1234561Detergent dispenser drawer2Control panel3Door opening handle4Rating plate5Drain filter6Adjustable feetDete

Child safety deviceThis appliance incorporates a special feature to prevent children and pets becomingtrapped inside the drum.Make sure that children

• Economy option10Spin reduction and Rinse Hold optionProgramme knob It allows you to switch the appliance On/Off and/or to select aprogramme.Display