IKEA LAGAN User Manual download pdf (Page 19)

Problem Possible cause Solution

The temperature in the ap-

pliance is too low/too high.

The door has been

opened too often.

Open the door only if necessa-

ry.

The temperature in the ap-

pliance is too low/too high.

There is no cold air circula-

tion in the appliance.

Make sure that there is cold

air circulation in the appliance.

Side panels of the appliance

are warm.

This is a normal state

caused by operation of the

heat exchanger.

Make sure that there is at least

30 mm of space between each

side of the appliance and the

surrounding furniture when the

ambient temperature exceeds

38°C.

There is too much con-

densed water on the rear

wall of the refrigerator.

Door was opened too fre-

quently.

Open the door only when nec-

essary.

There is too much con-

densed water on the rear

wall of the refrigerator.

Door was not closed com-

pletely.

Make sure the door is closed

completely.

There is too much con-

densed water on the rear

wall of the refrigerator.

Stored food was not wrap-

ped.

Wrap food in suitable pack-

aging before storing it in the

appliance.

Door does not open easily. You attempted to re-open

the door immediately after

closing.

Wait a few seconds between

closing and re-opening of the

door.

If your appliance is still not

working properly after making

the above checks, contact the

Authorised Service Centre. You

can find the list at the end of this

manual.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

the assembly instructions.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

Replacing the lamp

The appliance is equipped with a

longlife LED interior light.

Caution! Disconnect the plug

from the mains socket.

1. At the same time, with the fingers

expand up and down the transparent

cover and unhook it in the direction of

the arrows.

ENGLISH 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments