IKEA LAGAN User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
German degrees
(°dH)
French degrees
(°fH)
mmol/l Clarke de-
grees
Water softener level
<4 <7 <0.7 < 5
1
2)
1)
Factory setting.
2)
Do not use salt at this level.
Whether you use a standard detergent or
multi-tabs (with or without salt), set the
proper water hardness level to keep the
salt refill indicator active.
Multi-tabs containing salt are not
effective enough to soften hard
water.
How to set the water softener level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator flashes and the indicators
and are on.
2. Wait until the indicators
and
are off and the indicator flashes.
The indicator still flashes. The
intermittent flashing of the indicator
shows the current setting.
e.g. 5 flashes + pause + 5 flashes =
level 5.
3. Press programme button repeatedly to
change the setting. Each pressing of the
programme button increases the level
number. After reaching level 10, the
count starts again from level 1.
4. Press the on/off button to confirm the
setting.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default, this acoustic signal is activated and
it is possible to deactivate it.
In addition, an acoustic signal will sound
before the AutoOpen will open the door.
This acoustic signal stops only if AutoOpen
is deactivated.
How to deactivate the acoustic signal for
the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator
flashes and indicators
and are on.
2. Press the programme button
immediately.
The indicator and are on.
The indicator
flashes.
3. Wait until the indicator and
are off. The indicator still flashes.
The indicator shows the current
setting:
on = Acoustic signal on.
4. Press the programme button to change
the setting.
off = Acoustic signal off.
5. Press on/off confirm the setting.
AutoOpen
AutoOpen improves the drying results with
less energy consumption.
ENGLISH
10
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments